TIMER:
This feature is like a stopwatch,
in
that
you
can
clock the time it takes to get from one point
to another.
To operate, press the TIMER button until TIMER
OFF
0O:OO:OO
is displayed on the Driver Information Center
@IC).
Each of the fields for the hours, minutes and
seconds are two numeric digits.
Once TIMER
OFF
0O:OO:OO
is displayed, press the
TIMER button to start the timing feature. Press the
TIMER button again to stop it.
If
you will be starting
and stopping your vehicle
--
during a trip for
instance
--
the
TIMER
feature will automatically start
timing where it left
off
when you last stopped.
To
reset
it, press and hold the RESET button until the display
reads TIMER
0O:OO:OO.
Press the INFORMATION
button
to
exit from the TIMER function.
RESET
Pressing this button will reset the MPG AVG,
GAL FUEL USED, AVG
MPH
and OIL LIFE LEFT.
Pressing RESET when a non-resettable display appears
will cause a “recall” mode to occur. When this happens,
all Driver Information Center (DIC) warning messages
that have been displayed since the ignition key was
turned to
RUN
will redisplay. If no messages were
displayed, a MONITORED SYSTEMS
OK
message
will appear.
MPG
AVG
(Reset):
Press the INFORMATION button
to display the MPG AVG (Average Fuel Economy), then
press and hold the RESET button until
0.0
MPG AVG
is displayed.
GAL
FUEL
USED
(Reset):
Press the INFORMATION
button to display the GAL FUEL
USED
on the Driver
Information Center (DIC), then press and hold the
RESET button until
0.0
GAL FUEL
USED
is
displayed.
AVG
MPH
(Reset):
Press the INFORMATION
button to display the AVG MPH (Average Speed), then
press and hold the RESET button until
0.0
AVG
MPH
is
displayed.
OIL
LIFE
LEFT (Reset):
Press the INFORMATION
button
to
display the OIL LIFE LEFT, then press and
hold the RESET button until
100%
OIL LIFE LEFT is
displayed. (This only needs to be reset after you have
had the oil changed.)
2-80
To Next Page
Loading...
Need help?
General
