The cassette tape is broken. (Check to see if your
REV:
Press the left arrow to rewind the tape rapidly.
The radio will play while the tape reverses and
REV
will appear on the display. You may use your station
pushbuttons to tune to another radio station while
in
REV
mode. Press the left arrow again to return to
playing speed.
FF:
Press the right arrow to fast forward to another part
of the tape. The radio will play while the tape advances
and
FF
will appear on the display. You may use your
station pushbuttons to tune to another radio station
while in
W
mode. Press the right arrow again to
return to playing speed.
SEEK-TUNE:
Press the right arrow to seek to the next
selection on the tape. Press the left arrow to search for
the previous selection on the tape (REP will appear on
the display). Your tape must have at least three seconds
of silence between each selection for SEEK-TUNE to
work. The sound will mute while seeking.
SCAN:
Press this button. SCAN
FF
will appear on the
display until the next selection is found and then SCAN
PLAY will appear on the display. Use SCAN to listen
to
selections for a few seconds. The tape will
go
to
a
selection, stop for a few seconds, then
go
on
to
the next
selection. Press
this
button again to stop scanning.
tape is broken. Try a new tape.)
SIDE:
Press this button to change the side of the tape
that is playing. (PLAY shows on the display.)
SOURCE:
Press
this
button to select a source.
If
no
cassette tape is
in
the tape player, CASS appears on the
display and then the radio station appears briefly. The
display then reverts back to showing the time of day. Press
this
button again or
BAND
to switch back to the radio.
A
EJECT
Press the upward triangle button to remove
a tape. The radio will play. Eject may be activated with
the radio
off.
Cassette tapes may be loaded with the radio
off
but they will not start playing until the PWR button is
pressed. Press PWR or
turn
the ignition key
off
to stop
the cassette tape player. The tape will stay in the player
and resume play at the point where it stopped.
CLN:
If
this message appears on the display, the
cassette tape player needs to be cleaned.
It
will still play
tapes, but you should clean it as soon as possible to
prevent damage to the tapes and player. See “Care
of
Your Cassette Tape Player” in the Index. After you clean
the player, press and hold EJECT for five seconds to
reset the CLN indicator. The radio will display
---
to
show the indicator was reset.
Dolby Noise Reduction is manufactured under a license
from Dolby Laboratories Licensing Corporation. Dolby
and the double-D symbol are trademarks
of
Dolby
Laboratories Licensing Corporation.
3-17
To Next Page
Loading...
Need help?
General
