TUNE-SEEK:
When this button is pressed, it has two
positions. This button works the same, whether it is
pressed to the first or second position. Press this button
to seek to the next or previous selection on the tape.
Your tape must have at least three seconds
of
silence
between each selection for
TUNE-SEEK
to work. The
sound will mute while seeking.
SCAN:
Press
this
button to listen to selections for a few
seconds. The tape will go to a selection, stop for a few
seconds, then go on to the next selection. Press this
button again to stop scanning.
SIDE:
Press this button to change the side
of
the tape
that is playing.
A
EJECT
Press the upward triangle button to
remove a tape. The radio will play. Eject may be
activated with the radio
off
andor the vehicle
ignition
off.
CLEAN
TAPE:
If this message appears on
the
display,
the cassette tape player needs to be cleaned. It will still
play tapes, but you should clean it as soon as possible to
prevent damage to the tapes and player. See “Care of
Your Cassette Tape Player” in the Index. After
you
clean
the player, press and hold EJECT for three seconds to
reset the CLEAN TAPE indicator.
Dolby Noise Reduction is manufactured under a license
from Dolby Laboratories Licensing Corporation. Dolby
and the double-D symbol are trademarks
of
Dolby
Laboratories Licensing Corporation.
Auto CrO2 allows the cassette tape player to adjust to
the type of cassette tape for clearer sound for CrO2
cassette tapes.
Playing a Compact Disc
Insert a disc partway into the slot, label sidedp. The
player
will
pull it in. If the ignition and the radio are on
and the underlined compact disc symbol appears on the
display, the disc will begin playing. Compact discs may
be loaded with the radio
off
but they will not start
playing until the radio is on. If you want to insert a disc
when the ignition is
off,
first press EJECT.
The integral CD player can play the smaller
8
cm
compact discs. Full-size compact discs and the smaller
compact discs are loaded in the same manner.
To Next Page
Loading...
