4.
With the coolant surge tank pressure cap
off,
start the
engine and let it run until
you
can feel the upper
radiator hose getting hot. Watch out for the engine
cooling fans.
By
this time, the coolant level inside the coolant
surge tank may be lower.
If
the level is lower, add
more
of
the proper mixture to the coolant surge tank
until the level reaches about
2.5
inches
(6.4
cm)
below
the
base of the filler neck.
5.
Then replace the pressure cap. Be sure the arrows
on
the
pressure cap line up like this.
Start the engine and allow it to warm up. If the
CHECK
COOLANT LEVEL message does not appear on the
Driver Information Center, coolant
is
at the proper fill
level.
If
a CHECK
COOLANT
LEVEL message does
appear, repeat Steps
1
through
3
or see your dealer.
To Next Page
Loading...
Need help?
General
