0
There should not be any cargo or loading of the
vehicle, except it should have a full tank of gas and
one person or 160 lbs. (75 kg) on the driver’s seat.
Tires should be properly inflated.
0
Rock the vehicle to stabilize the suspension.
NOTICE:
L
To
make sure your headlamps are aimed
properly, read all the instructions before
beginning. Failure to follow these instructions
could cause damage to headlamp parts.
For the vertical adjustment, state inspection stations
generally will allow a reading of plus 0.76 degrees or
minus 0.76 degrees from the center of the bubble.
It is recommended that the upper limit not exceed plus
0.4
degrees from the center of the bubble. Other drivers
may flash their high beams at you if your adjustment
is
much above plus
0.4
degrees.
If you find that the headlamp aiming needs adjustment,
follow these steps:
..
.
,..
1.
Start by opening the hood and locating the vertical
and
horizontal aim indicators. The aiming screw for
the horizontal aim indicator is on the outboard side
of
the headlamp cover and the aiming screw for the
vertical aim indicator is on the inboard side.
6-39
To Next Page
Loading...
