CALIENT S Series User Manual

CALIENT OCS WebGUI Quick Start Guide
Doc. Part No. 460185-00
July 28, 2015
Rev. 0.2
Page 22 of 63
4.1.3.3 SNMP v3 Get/Set Parameters
To access the SNMP v3 agent, an SNMP v3 user needs to be configured. Table 3 lists the
parameters that can be added, deleted or modified by the system administrator to configure
a user. Figure 4 shows the parameters as they appear in the WebGUI.
If a user is being utilized in a Trap v3 configuration, the user cannot be modified or
deleted unless that specific Trap v3 configuration entry exists.
Table 3 – SNMP v3 Get/Set Parameters
Field Name
Description
Required
User Name
Unique SNMP v3 user name
Yes
User Type
Value can be RO (Read-Only) or
RW (Read-Write)
Yes
Security Level
This value can be Auth/NoPriv or
Auth/Priv ONLY
Yes
Auth Protocol
Authentication Protocol; value
can be MD5 or SHA
Yes, if Security Level
is Auth/NoPriv or
Auth/Priv ONLY

CALIENT S Series Specifications

General

Brand	CALIENT
Model	S Series
Category	Switch
Language	English