w Printing
384
4
Set the printing effects.
Set them if necessary. If you do not
need to set any printing effects, go to
step 5.
Contents displayed on the screen
differ depending on the printer.
Select the setting, then press <0>.
Select the desired printing effect, then
press <0>.
If the <ze> icons are displayed
brightly, you can also adjust the
printing effects (p.386).
* When you change the printing effects, changes are reflected in the image
displayed on the upper left of the screen. Note that the printed image may look
slightly different from the displayed image, which is only an approximation. This
also applies to [Brightness] and [Adjust levels] on page 386.
Printing Effect Description
EOff No automatic correction is applied.
EOn
Print with the printer’s standard colors. The image’s Exif data is
used to make automatic corrections.
EVIVID
Print with higher saturation to produce more vivid blues and
greens.
ENR
Image noise is reduced before printing.
0 B/W
Prints in black-and-white with true blacks.
0 Cool tone
Prints in black-and-white with cool, bluish blacks.
0
Warm tone
Prints in black-and-white with warm, yellowish blacks.
zNatural
Prints the image in the actual colors and contrast. No automatic
color adjustments are applied.
zNatural M
Printing characteristics are the same as the “Natural” setting.
However, this setting enables finer printing adjustments than
with “Natural.”
EDefault
Printing differs depending on the printer. For details, refer to the
printer’s instruction manual.
To Next Page
