Administrator password setting
Important
• This setting item is for the administrator.
You can specify or disable the administrator password.
Specifying the administrator password requires you to enter the password to change the machine settings or
connection settings.
Entering the administrator password is required to change the setting items in the following menus.
• ECO settings
• Quiet setting
• Web service setup
• FAX settings
• LAN settings
• Device user settings
• Language selection
• Firmware update
• Administrator password setting
• Operation restrictions
• Reset setting
When the confirmation screen to specify the administrator password is displayed, tap Yes. When the
message is displayed, tap OK.
The screen to show the range where the administrator password is valid is displayed.
Select the range, then specify the administrator password (0 to 32 alphanumeric characters).
Remote UI/Network Tool
Entering the administrator password is required to change the setting items using the Remote UI or IJ
Network Tool.
LCD/Remote UI/Network Tool
Entering the administrator password is required to change the setting items using the operation panel of
the machine, the Remote UI, or IJ Network Tool.
267
To Next Page