Canon MAXIFY MB2350 - Default Values Set at Factory (Network)

Default Values Set at Factory (Network)
Default Values of the LAN Connection
Item The default
Change LAN Disable LAN
SSID BJNPSETUP
Communication mode Infrastructure
Wireless LAN security Disable
IP address (IPv4) Auto setup
IP address (IPv6) Auto setup
Set printer name* XXXXXXXXXXXX
Enable/disable IPv6 Enable
Enable/disable WSD Enable
Timeout setting 1 minute
Enable/disable Bonjour Enable
Service name Canon MB2300 series
LPR protocol setting Enable
Wireless LAN DRX setting Enable
Wired LAN DRX setting Enable
("XX" represents alphanumeric characters.)
* The default value in this item varies by machine. You can check the value in this item using the
operation panel on the machine.
LAN settings
Default Values of the Access Point Mode
Item The default
SSID (access point name) XXXXXX-MB2300series
Wireless LAN security WPA2-PSK (AES)
Password Serial number of the machine
(XXXXXX is the last six digits of MAC address of the machine.)
285