Canon MAXIFY MB2350 - Setting the Administrator Password

Setting the Administrator Password
You can specify or disable the administrator password.
Specifying the administrator password requires you to enter the password to change the machine settings or
connection settings.
Entering the administrator password is required to change the setting items in the following menus.
• ECO settings
• Quiet setting
• Web service setup
• FAX settings
• LAN settings
• Device user settings
• Language selection
• Firmware update
• Administrator password setting
• Operation restrictions
• Reset setting
Follow the procedure below to specify the administrator password.
1.
Make sure that the machine is turned on.
2.
Flick the HOME screen, then tap Setup.
Using the Operation Panel
3.
Tap Device settings.
4.
Tap Administrator password setting.
5. When the confirmation screen to specify the administrator password is displayed, tap Yes.
6. Check the message, then tap OK.
7. Tap the range where the administrator password is valid.
Remote UI/Network Tool
Entering the administrator password is required to change the setting items using the Remote UI or
IJ Network Tool.
LCD/Remote UI/Network Tool
Entering the administrator password is required to change the setting items using the operation
panel of the machine, the Remote UI, or IJ Network Tool.
376