Two-Sided Copying
When Loading the Original on the platen glass:
• Before scanning:
When the preview function is activated, the machine starts pre-scanning before scanning the original.
When pre-scanning is finished, the screen below (preview screen) is displayed on the LCD.
A. Tap to rotate the original by 180 degrees.
B. Tap to start scanning the original.
C. Tap to rescan the original.
• After scanning:
The screen below appears after scanning each sheet of original.
A. Tap to start scanning the original.
Remove the sheet of original from the platen glass after scanning and load the next sheet on the
platen glass, then tap Scan.
B. Tap to start copying the original already scanned.
Note
• You can add the copying job while printing.
Adding the Copying Job (Reserve copy)
• If you use this function in combination with Two-sided copy, the screen above is displayed after
scanning the second sheet of original is complete. Follow the on-screen instructions to scan the
third and fourth sheet of original.
557
To Next Page
Loading...
