This product uses semiconductors that may be damaged by electrostatic discharge
(ESD). When handling, care must be taken so that the devices are not damaged.
Damage due to inappropriate handling is not covered by warranty.
Before performing any operations, check that the PlantWatchPRO box contains:
the two plastic faceplates (top and bottom); 1.
the user manual;2.
the device itself;3.
four screws (already inserted in position);4.
the terminals (six, already connected to the board); 5.
two resistors (inside the case).6.
WARNING: separate as much as possible the probe and digital input signal
cables from the cables carrying inductive loads and power cables to avoid
possible electromagnetic disturbance.
Never run power cables (including the electrical panel wiring) and signal
cables in the same conduits.
To Next Page
Loading...
