Message appearing when the maximum number of sold units per Clerk exceeds 50ea
Message appearing as no sales occur when the buffer is filled up with data
When Negative sales are executed
Network error (Pay buffer is filled up with data)
2.. No sales data in void Last Sale
3. No Data in Table
Only account balancing is entered without outputting of labels or total add
No reference information exists in relevant PLU when Function key(PLU
REFERENCE, #9) is pushed after calling PLU
Message appearing under the conditions of not allowing sales in Floating mode
[ADD] "Message of operation disabled when Add is operated in Clerk mode"
When Tare clearing was attempted without set Tare
Tare higher than the set Tare cannot be set upon continuous use of Tare
Tare lower than the set Tare cannot be set upon continuous use of Tare
Multiply Negative is not allowed when Multiply print is attempted using -> “X” key after
setting Negative ON.
No PLU available for the relevant number.
1. Not found customer. : When Customer cannot be found in credit sale
2. Not Found clerk. : Message appearing when Clerk is not set
No total price, When TTL button was pushed without Total Price
Having been changed is informed if map of the set key is changed when the current
Dept is changed with [DEPT#] key.
To Next Page
Loading...
Need help?
General
