The Router IP address should be set to 1.1.1.3 using the conf prot command.
Two user profiles are required, one for the seamless connections
(warehouse and development), and one for the dialogue connections (sales).
To edit each user profile, enter the
conf up ed command followed by the
profile number, and complete the forms as follows:
Router : Watford CONFIGURE USER PROFILE FORM REL x.y
-------------------------------------------------------------------------------
Name : Seamless Number : 1
Escape seq : Txt :
Disc. seq : Txt :
Switch seq1 : Txt :
Switch seq2 : Txt :
Switch seq3 : Txt :
Switch seq4 : Txt :
Directory banner : ENABLE Manager Login : ENABLE
Free Service selection : ENABLE Session Quota : 1
Inactivity disc. time : Parity : EVEN
Go-Ahead : NOT SUPPRESSED Binary : ENABLED
CR map : CR Break Map : DISABLED
-------------------------------------------------------------------------------
PF2 - Help ^R - Restore
PF1 - Submit ^C - Abort
-------------------------------------------------------------------------------
This profile (named Seamless) does not allow dialogue to be entered, or
allow more than one session to be created. It is therefore suitable for use
both by development and warehouse staff.
X870-300351 Issue 1 E-2 Rev.0
To Next Page
Loading...
