4.6.2 Connection Status/Statistics Menu (stat conn command)
Router : Watford CONNECTION STATUS/STATISTICS Rel x.y
--------------------------------------------------------------------------------
LAN STATISTICS=
TELNET: Tx Data Chr : Rx Data Chars :
Tx Non-Data : Rx Non-Data :
TCP: Local Ip address : Rem IP address :
Local Port : Rem Port :
Tx Packets : Rx packets :
Re-Transmit : Checksum errs :
Incoming Window : RTT :
Outgoing Window :
WAN STATISTICS =
PAD: Tx Data Chars : Rx Data Chars :
Tx state (rcvd) : Rx State (sent) : Xon
CONNID - Select connection id RE - Reset Stats
--------------------------------------------------------------------------------
PF2 - Help PF4 - Main Menu
PF3 - Prev Menu
--------------------------------------------------------------------------------
(stat conn) Enter command :
This screen displays the connection-oriented information, i.e. TELNET and
TCP statistics for the LAN side of a connection, and channel statistics for
the X.25 side. If a connection is in User Dialogue or Manager mode, or the
session is not selected by the user, only the Channel information is
displayed (according to the Channel number requested). The Channel
numbers can be obtained from the General Status Menu; see Section 4.6.1.
CONNID command selects the LAN or WAN session to be displayed, e.g. 65.
RE command resets the statistics for the currently displayed connection.
LAN STATISTICS = TTT
This is the connid number of the TCP/TELNET connection currently
displayed.
X870-300351 Issue 1 4-46 Rev.0
To Next Page
Loading...
