Case 8000 Series - Initial Entry to the Manager

4.2.5 Initial Entry to the Manager
After connecting to Router, you can gain entry to the manager by using the
logon command. Once you are logged on, the manager assumes it is
communicating with a terminal of the type configured as the 'manager
terminal type'. If one has not already been configured (e.g. after cold start),
you are presented with the following terminal selection menu (in TTY
mode):
Terminal Selection Menu
1 - VT100
2 - ADM3A
3 - CIFER2605
3 - IBM3101
5 - Define
Enter selection number:
If you enter 5 (Define), a minimum set of the terminal parameters are
prompted for in teletype mode (see Section 2.8).
Router then uses the selected terminal characteristics and displays the
Main Menu.
X870-300351 Issue 1 4-6 Rev.0