4.5.4 CLEAR (conn cl command)
This command can be used to clear connections. If the specified connection
is a user (source), this clears all the calls (sessions) associated with the
user. Connections are identified by their channel number (<connId>).
These numbers can be obtained from the status screens.
4.5.5 TRACE (disable:
di trace command)
(enable:
en trace command)
Disabling TRACE prevents diagnostic trace information being sent to the
card's trace port.
Enabling TRACE causes diagnostic trace information to be sent to the
card's trace ports.
X870-300351 Issue 1 4-42 Rev.0
To Next Page
Loading...
