Router : Watford CONFIGURE LAN SERVICE FORM REL x.y
-------------------------------------------------------------------------------
Name : Stock
X.121 Address : 11000017050 Sub-Address : 01
Internet : 1.1.1.2 TCP Port : 23
Address
Password :
User Prof : Seamless Service Prof : Stocklogin
-------------------------------------------------------------------------------
PF2 - Help ^R - Restore
PF1 - Submit ^C - Abort
-------------------------------------------------------------------------------
This service makes use of an X.121 address to route STOCK calls from X.25
to the LAN.
Once all these items have been configured, then the services should be
enabled (
en lan DevSys, en lan Sales, en lan Stock).
The above configuration allows the development staff to contact X.25 and
simply enter the service name
DEVSYS, which then automatically connects
them to the development system over the Ethernet network. Warehouse
staff also follow the same procedure using the
STOCK service name; in this
case they will be connected to the commercial system and logged in as
STOCK.
The sales staff contact the WAN and enter the
SALES service name. This
automatically routes them to the SALES service on the commercial
system. They may then enter
ESC PF4 on the keyboard. This brings them
into dialogue with Router, which then requests that they enter a service,
e.g. STOCK. Upon entering
STOCK, TGate connects them to the STOCK
service while leaving the SALES service available on session 1. The user
can then switch between service by pressing
ESC PF1 for SALES and ESC PF2
for STOCK.
X870-300351 Issue 1 E-9 Rev.0
To Next Page
