conf gen General configuration. Manager password, manager
terminal type and slot number.
conf prot Protocol configuration. IP address. Other fields can be
left as defaults, unless you are familiar with TCP/IP and
wish to optimise these parameters to match your
network.
rtr gen Subnet mask and IP Broadcast Address.
conf mess Welcome banner and general messages. Configure the
welcome message that you desire. This will only be
presented to users who enter dialogue with the gateway.
Configure general messages and the user prompt.
conf prof user User profile configuration. Configure each of the
(
conf up) user profiles that you require. This generally divides
into 'seamless' users and 'dialogue' users.
conf prof serv Service profiles. Configure each of the service
(
conf sp) profiles.
conf serv wan WAN services. Configure and enable each of the WAN
(
conf wan) services that you require.
conf serv lan LAN services. Configure and enable each of the LAN
(
conf lan) services that you require.
conf gen The default user and service profiles may need to be
changed.
conf prof term The manager-defined terminal configuration may
(
conf tp) require completion and/or personalising.
rtr rc In order to utilise the IP Routing function, the addresses
of all other Routers which may be accessed by the
Router across the X.25 network will need to be
configured.
rtr rt Static Routes and a Default route may be configured.
The above gives a quick guide to configuring Router. It is strongly advised
that this manual be fully studied and the configuration planned, before
attempting to actually configure Router; thus ensuring that the user's
networking needs are fulfilled as effectively as possible.
X870-300351 Issue 1 3-5 Rev.0
To Next Page
Loading...
