Washing
The washing method is used if element is heavily contaminated and sooty.
Wash the element in water using Case Filter Element Cleaner Part No. A4091O.
Mix 2 ounces (60 grams) of cleaner to 1 gallon (3.8 litres) of water at 70° to
100*F (21° to 38°
C).
Soak element for 15minutes. Rinse thoroughly with hose.
Do not use water pressure over 40 psi (276 kPa) at the nozzle. Let air dry
completely before installing. This usually requires 24 to 72 hours.
IMPORTANT: Do not use air pressure to dry filter element. It would be a
good practice to have a second filter element to use while the recently washed
element is drying.
Seat Belts
1. Keep sharp edges and damaging objects away from belts.
2. Periodically inspect belts, buckles and anchors for damage that could
lessen the effectiveness of the restraint system.
3. Have questioned parts replaced.
4. Replace belts if cut, weakened, frayed, or subjected to collision loads.
5. Check that anchor mounting bolts are tightened to the seat mounting
bracket.
6. Keep seat belts clean and dry.
7. Clean only with a mild soap solution and lukewarm water.
8. Do not bleach or dye belts since this may severely weaken belts.
126
To Next Page
Loading...
