...., Starting Aids
Cold Start (Before Machine SIN 9125771)
The cold start system electrically injects ether into the air intake system.
To operate, turn key switch to Run position and depress cold start button for
one second. Wait two seconds and crank engine.
Cold Start (With Machine SIN 9125771 and After)
The cold start system electrically injects ether into the air intake system. It
is used to aid engine starting in cold weather. The system injects a measured
amount of ether each time the button is pushed in. Itwill operate only when the
key switch is in the Start position. To operate, proceed as follows:
1. Refer to "Starting the Engine" on pages 52 or 53.
2. Push down the foot throttle until it is
1/3
open.
3. Turn the key of the ignition switch to the Start position.
4. After the starter motor is engaged, push and release the Cold Start button
two times. When the engine starts, release the key.
NOTE:
If the engine runs for a short time and then stops, engage the
starter again, push and release the Cold Start button one time. If the engine
does not fi re, stop injecti ng ether and check the supply of ether in the Cold
Start can.
NOTE:
When installing new ether cans, refer to pages 120 and 121.
55
To Next Page
Loading...
