EasyManua.ls Logo

Case W14 - Transmission Hydraulic System

Case W14
143 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TRANSMISSION-CONVERTER HYDRAULIC SYSTEM
c..
Oil Level
Every 50 hours of operation oreach week, check the transmission oil level.
The dipstick cap is at the left-hand side of the transmission.
DANGER:
Keep clear of this area when engine is running. Machine
h
could pivot unless the frame pivot safety link is in its lock position. After
.. servicing is completed, unlock the safety link and secure in place on the
rear frame pivot. 0-32-4
NOTE: One quart of oil will raise the oil level approximately 1/2 inch (12
mm). To remove the dipstick, turn the T-handle counterclockwise and lift up.
To install, push all the way in and turn T-handle clockwise until tight.
Cold Oil Check
1. Before starting engine, remove dipstick and check oil level. If oil is at or
near FULL mark no further checks are necessary. Proceed to step 3 if oil is
above ADD mark.
2. If oil level is below the ADD mark, add oil to raise oil level to or slightly
above the ADD mark.
3. Start engine and run at low idle with transmission in neutral for approxi-
mately two minutes. Recheck oil level and add oil as required to establish
oil level at or slightly above the ADD mark.
114

Table of Contents

Related product manuals