Case W14 - Grease Fittings

GREASE FITTINGS
Lubricate the machine according to the intervals given in the maintenance
chart unless you operate the machine in severe conditions. If you operate the
machine in severe conditions, lubricate the machine more frequently. Remove
all dirt from the grease fittings before you lubricate.
Loader
1. Tilt cylinder pivots (2 each side) 4
2. Lift arm pivots (2 each side) 4
3. Lift cylinder pivots (2 each side) 4
4. Tilt bellcrank pivots (2 each side) 4
5. Bucket pivots (2 each side) 4
6. Center pivots 2
4-ln-1 bucket clam pivots (not shown) (1 each side) 2
Clam cylinder pivots (not shown) (2 each side) 4
7. Rear axle trunnion pivots (2 left side) 2
77