Hot Oil Check
1. With transmission at operating temperature (needle in green zone on
gauge), place transmission in neutral and run engine at low idle. Remove
dipstick and check oil level. The oil level should be between the ADD and
FULL marks.
2. If oil is below the ADD mark, add oil as required to raise the oil level to the
FULL mark.
Oil Change and Filter Service
Every 1000 hours (1) change transmission oil, (2) change transmission
filter element, (3) clean the oil strainer and (4) clean the breather.
1. Have oil at operating temperature. Remove drain plug. Allow oil to drain
thoroughly.
RI::;~T 51]" OF TRA:iS'!ISSIO'!
2. Remove oil strainer and gasket. Discard gasket. Clean strainer in solvent.
Dry with compressed air.
NOTE: Do not reinstall drain plug or oil strainer until the transmission
filter element has been changed.
115
To Next Page
Loading...
