3. Remove breather. Clean in solvent, or replace if damaged. Dry the breather
with compressed air and install the breather.
4. Change transmission filter element.
a. The filter is located at the right-hand side of the engine near the
flywheel housing.
b. Remove filter cover, backup ring, O-ring seal, retaining spring and
relief valve. Check O-ring and backup ring for damage and deteriora-
tion and replace as required.
c. Remove and discard filter element. Clean filter body with a clean dry
cloth. Do not use cleaning solvent unless lines are disconncted from
filter body.
d. Install new filter element. Reinstall valve, spring, seal and backup ring.
e. Reinstall cover using care not to cut O-ring. Torque cover 20 to 35
foot-pounds (27 - 47 N m).
116
To Next Page
Loading...
