Vacuum area to remove excess loose dirt, Always clean at least a full trim
panel or section of trim. Mask adjacent trim along stitch. Mix detergent type
foam cleaners in strict accordance with directions on label of container. Use
foam only on a clean sponge or soft bristle brush.
NOTE: Do not wet fabric excessively or rub harshly with brush. Wipe
clean with a slightly damp absorbent towel or cloth. Immediately after clean-
ing fabric, dry fabric with a dry towel.
Rewipe fabric with dry absorbent towel or cloth to restore the luster of the
trim and to eliminate any dried residue.
128
To Next Page
Loading...
