ROPS Safety Precautions
h
WARNING:
Do not remove the ROPS except for service. Install the
.. ROPS correctly before you operate the machine again. 3-10-A
WARNING:
Do not modify ROPSin any manner. Unauthorized moditi-
A
cations such as welding, drilling, cutting or adding attachments could
.. weaken the structure and reduce your protection. Replace ROPS if sub-
jected to rollover or damage. Do not attempt to repair. See operator's
manual for complete instructions and inspection requirements. 0-46-91
WARNING:
Do not Install attachments that will cause the total
h
gross vehicle weight of the machine to exceed the weight shown
In
.. the "FOR MAXIMUM GROSS VEHICLE WEIGHT" space on the
ROPS label. D-46-56-A
',,1'\'1,
9
JICase
M, .". "
®
,
"
Hacrne Wisconsin
53404
USA
'0' ,",um'ONoNW14.W14H.W14FL TYPE-CERTIFICATION FOR
W1B.W20. W20B. & W24C ROLLOVER
ARTICULATED LOADERS PROTECTIVE STRUCTURES
PERfORMANCE STAN DAR OS
MEASURED IN ACCORDANCE WITH
seeJ231 ,., J394a s..
&
J1040a
o
o
A
WARNING:
Special hardware IS used to fasten the ROPS to the
machine. You must use only the replacement parts shown
In
the Case
parts catalog for this machine. 4-9-A
h
WARNING:
Always fasten the seat belt before you start the engine
.. Make sure the buckle for the seat belt
IS
fastened correctly 8-5-A
21
To Next Page
Loading...
