~
Booster Battery
The following instructions give the correct method of connecting the
booster battery to the starter motor solenoid of the machine. Two persons are
required for this procedure.
1. The booster battery must havea total of 24 volts.
2. Whenyou areseatedin the operator's seatwith the seatbelt fastened, have
the other person connect the jumper cables. See the following photo-
graph.
3. Connect the positive
(+)
jumper cable of the booster battery to the Battery
terminal of the starter motor solenoid.
4. Connect the negative (-) jumper cable of the booster battery to a good
engine ground. This ground must be free of paint or dirt.
5. Sit in the operator's seatand then start the engine. See"Procedure to Start
the Engine" on pages52 or 53.
6. Havethe other person disconnect the jumper cables.
57
To Next Page
Loading...
