1. Bucket Control in Rollback Position
2. Lift Arm Control in Float Position
At the end of the cycle, the bucket leverwill automatically release from the
Rollback position and return to Hold position. The lift arm lever will remain in
the Float position and must be manually returned to the Hold position.
Bucket Height Control
This control enables the operator to preset the dump height of the bucket
when loading hoppers, trucks, etc. Move the lift arm lever to the Raise position.
In this position the lever is detented and will return automatically to the Hold
position at the end of the cycle. The bucket will be raised and stopped automat-
ically when the desired height is reached. For height adjustment, see page 134.
Clutch Cutout
A clutch cutout system is built into the brake system. The clutch cutout
provides a convenient means of temporarily disengaging the transmission to
make full engine power available to operate the loader.
To engage the clutch cutout, depress the left-hand brake pedal. When you
let up on the pedal, the transmision is re-engaged. The right-hand brake pedal
has no effect on clutch cutout.
WARNING:
Keep the transmission in low gear when going down
h
hills. Only use the right brake pedal to slow or stop the machine. The
,,'eft brake pedal allows the machine to freewheel before the brake is
applied.
00
not allow the machine to freewheel down the hill.
22-2-A
66
To Next Page
Loading...
