Group calls
TH1n - User Guide PS11366AENAA01
This document is the property of Cassidian and should not be copied or circulated without permission.
37/115
Select
Menu
→
Talk grou ps
→
Group settings. To change the priority of the
home group, select Home group priority; if you do not want to scan the home
group, select Off. To view the folder and group name of the home group,
select Home group. To change the home group, press
Change
, and select
the new home group.
You can easily select the home group by pressing and holding the back key. If
voice feedback is activated, the radio plays "Home". When the home group
name is displayed in the idle mode, press and hold the PTT key. You can start
speaking after a short tone is played and (transmitting) appears on the
display.
When the key has been parameterised to function as the duty key, you
can also set the radio to make a call to the home group when you press and
hold the duty key . See Duty key setting on page 87. When you talk, press
and hold the duty key .
Dynamic talk groups
Dynamic talk groups can be added to and removed from the memory of the
radio over the air by your service provider or network operator. When groups
are added or removed, a notification is displayed, such as Group added. A
notification tone may also be played. Your organisation can define whether
the tone is played or not. It is also possible to set the tone On or Off by
selecting
Menu
→
Talk groups
→
Group settings
→
DGNA tone.
To view the changes, press
View
. The changes are saved in the Group
journal; see Group journal on page 46.
In each folder, the dynamic groups are shown at the end of the group list if the
folder has been set to show dynamic groups. For details, contact your
network operator or service provider.
Invisible groups
Your organisation can define groups that are not shown in the group lists.
However, you may receive calls from these groups, and the group is visible
during the call.
Polaris_en_print.book Page 37 Tuesday, October 23, 2012 12:30 PM
To Next Page
Loading...