page 20 www.centsys.com
Step 5
Swing the gate to the open position,
(same position as step 2) and mark
“S5” on the ground, then draw the
setup line through “S4” & “S5” and
extend it away from the driveway.
FIGURE 10. MARKING SETUP LINE
FIGURE 11. LOCATE POSITION OF PEDESTAL
S4
Setup
line
60mm
S5
PillarWall
Step 7
Lie the Drive Arm over the setup line
so that the end of the Drive Arm lies
directly over mark “S5”. The Pedestal
position lies 60mm closer to the wall
from centre line of the Drive Arm
mounting hole.
FIGURE 12. RECOMMENDED LOCATION OF
PEDESTAL
60mm
Setup
line
Drive
arm
Pedestal
Gate
bracket
S5
S4
S5
Setup
line
OPERATOR INSTALLATIONSECTION 6
Step 6
Pedestals can be mounted anywhere
along a line 133mm away from the
setup line towards the pillar.
Recommended position
Drive Arm end just touches
the gate (see Step 7).
To Next Page
Loading...
