Cessna 182 - Page 92

2-16
10. Prop
Cycle - move toward low rpm
(coarse pitch)
RPM decrease of 200-300
RPM, then reset full fine
CAUTION
Monitor MAP to ensure 20" is
not exceeded
11. Suction
Confirm 4.5 – 5.5 in HG
12. Alternator
Confirm charging
13. Idle Check
Confirm IDLE at 650-750
RPM,
14. Throttle
Set 1000 RPM
15. Mixture
Function
Lean gradually until engine
falters, then IMMEDIATELY
reset to full rich to prevent
engine shutdown. Very little
movement of the mixture
control is required.
Figure 2-12 Run-up