CG VSR239p5 - 5.2 Standard Function Parameters

Emotron VS Series Quick Start Guide
- 47 -
Chapter 5 List of Parameter
Group A0～L1 are standard function parameters. Group U0 is status monitoring parameters.
Group U1 is fault record parameters.
The symbols in the function code table are described as follows:
"△ " means the value of this parameter can be modified in stop and running status of drive;
"×" means the value of this parameter cannot be modified when drive is running;
"⊙" means this parameter is a measured value that cannot be modified;
Default: The value when restored to factory default. Neither measured parameter value nor
recorded value will be restored.
Setting Range: the scope of setting and display of parameters
VS Series parameter groups are listed below:
Category
Parameter Group
System Parameters
A0: System Parameters
Basic Parameters
b0: Frequency Command
b1: Start/Stop Control Start/Stop Control
b2: Accelerate/Decelerate Parameters
Input & Output Terminals
C0: Digital Input
C1: Digital Output
C2: Analog and Pulse Input
C3: Analog and Pulse Output
C4: Virtual IO
Motor and Control Parameters
d0: Parameters of Motor 1
d1: V/f Control Parameters of Motor 1
d2: Vector Control Parameters of Motor 1
d3: Parameters of Motor 2
d4: V/f Control Parameters of Motor 2
d5: Vector Control Parameters of Motor 2
Protection Parameters
E0: Protection Parameters
Application Parameters
F0: Process PID
F1: Multi-Reference and Simple PLC Function
F2: Swing Frequency, Fixed Length , Count and
Wakeup
F3: Timing and Comparator
Communication Parameters
H0: Communication Parameters
Keys and Display of Keypad
Parameters
L0: Keys and Display of Keypad Parameters
User-defined Display Parameters
L1: User-defined Display Parameters
Monitoring Parameters
U0: Status monitoring
U1: Fault record