CG VSR239p5 - Chapter 4 Operation and Display; Introduction of Lcd Keypad

Emotron VS Series Quick Start Guide
- 39 -
Chapter 4 Operation and display
4.1 Introduction of LCD Keypad
As a human-machine interface, you can modify the parameters, monitor the working status and
start or stop the inverter by operating the keypad. Its appearance and function area as shown in the
following figure:
Fig 4-1 Keypad
4.1.1 Key and potentiometer Functions on keypad
There are 10 keys on the keypad, whose functions are as shown in Table 4-1.
Table 4-1 Key functions on keypad
Symbol
Name
Function
Escape
Enter or exit Level I menu
Enter
Enter the menu interfaces level by level, and
confirm the parameter setting
Increment
Increase data or function code
Decrement
Decrease data or function code
Right
Select the digit to be modified when modifying
parameters
Left
Select the digit to be modified when modifying
parameters
Multifunction
Change the control mode
Run FWD
Start the inverter forward in the keypad control
mode
Run REV
Start the inverter reversal in the keypad control
mode
Stop/Reset
Stop the inverter when it is in the running state and
perform the reset operation when it is in the fault
state. The functions of this key are restricted in
L0.01.