CIGWELD WeldSkill 4R Wirefeeder - 2.06 User Responsibility

WELDSKILL 250, 350 INTRODUCTION
Introduction 2-2 Manual 0-5186
2.06 User Responsibility
This equipment will perform as per the information con-
tained herein when installed, operated, maintained and
repaired in accordance with the instructions provided.
This equipment must be checked periodically. Defective
equipment (including welding leads) should not be used.
Parts that are broken, missing, plainly worn, distorted or
contaminated, should be replaced immediately. Should
such repairs or replacements become necessary, it is
recommended that such repairs be carried out by ap-
propriately qualified persons approved by CIGWELD.
Advice in this regard can be obtained by contacting
accredited CIGWELD Distributor.
This equipment or any of its parts should not be altered
from standard specification without prior written ap-
proval of CIGWELD. The user of this equipment shall
have the sole responsibility for any malfunction which
results from improper use or unauthorised modifica-
tion from standard specification, faulty maintenance,
damage or improper repair by anyone other than ap-
propriately qualified persons approved by CIGWELD.
2.07 Packaged Items
WeldSkill 250 MIG Plant (Part No: W1004500)
(South Pacific Version)
• WeldSkill250MIGPowerSource(compact)
• TwecoWeldSkillFabgun250MIGTorch
• Worklead
• WeldSkillArgonRegulator/Flowmeter
• CylinderChain
• 200mmSpoolAdaptor
• Feedrolls:0.6/0.8mmVGroove;
0.9/1.2mm V Groove (fitted),
1.0/1.2mm U Groove;
0.8/0.9mm V Knurled, 1.2/1.6mm V Knurled.
• Contact tips: 0.6mm; 0.8mm, 0.9mm
(fitted);1.0mm, 1.2mm, 1.6mm
• ShieldingGasHoseAssembly
• OperatingManual
WeldSkill 350 MIG Plant (Part No: W1004600)
(South Pacific Version)
• WeldSkill350MIGPowerSource(compact)
• TwecoWeldSkillFabgun400MIGTorch
• Worklead
• WeldSkillArgonRegulator/Flowmeter
• CylinderChain
• 200mmSpoolAdaptor
• Feedrolls:0.6/0.8mmVGroove;
0.9/1.2mm V Groove (fitted),
1.0/1.2mm U Groove;
1.2/1.6mm U Groove, 0.8/0.9mm V Knurled,
1.2/1.6mm V Knurled.
• Contacttips: 0.6mm; 0.8mm, 0.9mm (tted);
1.0mm, 1.2mm, 1.6mm
• ShieldingGasHoseAssembly
• OperatingManual