3-2012
Plus 42 - 45 - 50 - 55
37
3. Insert the wheels’ axle shafts into the ma-
chine’s axle.
4. Adapt the wheels’ track to that of the tractor.
5. Lock the axle shafts by means of the axle
screws.
6. Start the tractor and keep the sprayer lifted
during the transfers, lowering it to carry out
the treatment.
THE SPRAYER MUST BE LIFTED AT
EVERY DIRECTION CHANGE MAKING
SURE THAT THE WHEELS ARE NOT
RESTING ON THE GROUND.
The utilisation of NON ORIGINAL pairs of wheels not equipped with mud scrapers will
nullify the machine’s warranty.
The operating pressure of the tyres is indicated on the decal placed on the rim of each
wheel.
00029
WHEEL WITH
AXLE SHAFT
LOCKING
SCREWS
FRAME
MUD SCRAPER
7.3 - SWIVELLING DEVICE
It is an accessory used to modify the direction of
the spraying during the use of the sprayer; it can
be used only with the distribution devices with
delivery on the one side.
There is two type of swivelling device: manual
controlled or electrical with remote control panel.
All indications and instructions are
provided in the “Distribution heads -
Operation and maintenance instruc-
tion” booklet of the distribution devi-
ces with which it can be used.
®
Remote Control
00616
00617
MANUAL
SWIVELLING
DEVICE
ELECTRICAL
SWIVELLING DEVICE
WITH CONTROL PANEL
01125
To Next Page
Loading...
