Plus 42 - 45 - 50 - 55
3-2012
50
Or
11b.Spraying the rinsing water in the previously treated area. Discharge the remaining water of
the tank and pipes (about 5,6 lt.), gathering it in a proper container to waste it following the
country rules or use it again, putting in the tank, for a next treatment if thi will be suitable with
the product tu use.
if the machine HAS NOT a spray-line rinsing tank:
a. Put about 15 lt.of clean water in the tank and spraying it in the already treated area.
b. Wash the tank:
1. Put in the tank a quantity of clean water equal to almost 10% of tank capacity, with the agitator
while running.
2a. Discharge the rinsing water in a proper area provided with a drain basin for the collection and
take care of waste according to the country rules.
Or
2b. Spraying the rinsing water in the already treated area. Then, discharge the remainig water
of the tank and pipes (about 5,6lt) gathering it in a proper container to waste it following the
rules or use it again, putting it again in the tank, for a next treatment, if this will be suitable with
the product to use.
c. Wash the machine externally:
To wash it externally DO NOT USE high pressure washer (MAX 5 bar).
When each treatment has finished, it must wash the sprayer outside, in a proper area provided with
a drain basin for collection and subsequently treatment of rinsing water.
These area are forbidden to unauthorized personnel, children and pets.
To outside sprayer rinsing, it is possible to use proper cleaning products and biodegradable to make
the operation easier.
When the rinsing is finished, switch on the fan for few second (about 10) to remove residual water
on carter and pipes which lead the flow to the sprayhead.
The use of detergent products for the cleaning operations is allowed only in the
observance of the regulations in force. For these, the operator must gather the
relevant information from the specifically appointed bodies ruling on this subject.
d. Check the efficiency of the distribution device (head) and the cleaning of the pulverising points
(diffusers), possibly replacing them if found to be damaged.
e. Clean out the filter cartridge.
f. Keep the machine on a plane surface with a suitable consistency, in a ventilated place, sheltered
from rain or sun: sunrays are the worst enemies of plastic and rubber parts.
To Next Page
Loading...
