4
Enter Setup
1166/1266 Barcode Scanner User Guide
DIRECT CHARGING
The battery may not be charged to full for shipment. When you first receive the package,
you will need to charge the battery to full before using the scanner.
Note: (1) It is recommended that the charging devices be operated at room temperature
(18°C to 25°C) for optimal performance.
(2) The charging devices will not charge the battery when the temperature drops
below 0°C or exceeds 40°C.
If you do not have 3666 for charging, all you need to do is —
1) Install the battery to the scanner.
2) Connect one end of the power supply cord to the DC power jack at the bottom of the
scanner.
3) Connect the other end of the power supply cord to a suitable power outlet.
4) The scanner LED will be flashing red during charging. When the charging is done, the
LED will turn solid red.
CHARGING & COMMUNICATIONS VIA 3666
1) Install the battery to the scanner.
2) Seat the scanner in the 3666 base.
3) Connect one end of the power supply cord to the DC power jack at the back of 3666.
4) Connect the other end of the power supply cord to a suitable power outlet.
5) Connect 3666 to your computer or notebook via the interface cable.
6) The LED for power indication on 3666 will become solid red.
7) The scanner LED will be flashing red during charging. When the charging is done, the
LED will turn solid red.
8) The LED for communications on 3666 will first become solid red while attempting to
connect with the scanner. Refer to the table above for details.
Note: It takes approximately 2 hours to charge the battery to full. However, it takes
approximately 4 hours to charge the spare battery.
Install a spare battery for charging
if necessary.
To Next Page
Loading...
Need help?
General
