168
Enter Setup
1166/1266 Barcode Scanner User Guide
ENTERING PIN CODE FOR AUTHENTICATION
USE PRESET PIN
1) In the configuration mode, read the barcode below to use a preset PIN for
authentication.
Use Preset PIN
2) Read one of the barcodes to specify the PIN code, in decimal or hexadecimal.
By default, the PIN code is set to “0000”. Maximum 6 characters are allowed.
Enter PIN in
Hexadecimal…
3) Read the “
Hexadecimal Value” barcode on page 166 for the desired digits or character
string.
4) Read the “Validate” barcode to complete this setting.
DISABLE AUTHENTICATION
In the configuration mode, read the barcode below to disable authentication (= No PIN).
*No PIN
Note: When using BT HID, some device driver may not support pre-defined PIN code for
authentication. In this case, we suggest applying no authentication instead.
To Previous Page
Loading...
Need help?
General
