62
Enter Setup
1166/1266 Barcode Scanner User Guide
IN THIS CHAPTER
3.1 Connecting via 3666 .................................................. 62
3.2 Connecting via Bluetooth
®
Dongle ................................ 65
3.1 CONNECTING VIA 3666
By default, the interface of 3666 is set to “Keyboard Wedge”. Use the interface cable to
connect the scanner via 3666 to PC. You can have up to seven scanners connected to
one computer at the same time.
3.1.1 CONNECT TO 3666
You can connect any scanner to 3666 by having the scanner read the two labels at the
back of 3666. The scanner will respond with one beep upon reading the first label, and
two beeps (high-low tone) upon reading the second label.
“Set Connection” label
“Serial Number” label
After reading these labels, the scanner will stay active for a preset period of time (1
minute) trying to connect to the 3666 base while its LED is flashing blue (On/Off ratio
1:1). Once connected, the scanner will respond with three beeps (tone ascending from
low to high), and the LED becomes flashing blue (On/Off ratio 1:6). When getting out of
range, the scanner will respond with three short beeps (tone descending from high to
low).
Read the “Set Connection” label first, and then the “Serial Number” label. If the “Set
Connection” label on 3666 is illegible, try this one —
Set Connection
Note: The 3666 settings will overwrite the interface-related settings on the scanners that
are currently connected to 3666.
To Next Page
Loading...
Need help?
General
