9
Update
The configuration of the scanner can be done by reading the setup barcodes contained in
this manual or via the ScanManager software.
This section describes the procedure of configuring the scanner by reading the setup
barcodes and provides some examples for demonstration.
Configuration Mode
1. Install the battery to the scanner, and the scanner will turn on automatically. It will respond
with a long beep and its LED will come on and off shortly.
2. Have the scanner read the “Enter Setup” barcode. It will respond with six beeps and its LED
indicator will become solid blue after reading the barcode.
3. Have the scanner read more setup barcodes… Most of the setup barcodes are normal. The
scanner will respond with two beeps (high-low tone). For special setup barcodes, it requires
reading more than one setup barcode to complete the setting.
4. Have the scanner read the “Update” or “Abort” barcode. It will respond with six beeps and its
LED indicator will become solid blue after reading the barcode.
5. The scanner will restart automatically upon reading the “Update” or “Abort” barcode. It will
respond with a long beep and its LED will come on and off shortly.
Note: Refer to Appendix II Host Serial Commands for how to configure the 3666 base by
having the scanner read 3666-related setup barcodes or using serial commands.
QUICK START