57
Update
Chapter 2
Selecting Output Interface
2.3.3 INTER-CHARACTER DELAY
By default, the inter-character delay is set to zero. Specify a value, ranging from 0 to
255 in units of millisecond, to match the computer response time of the keyboard
interface. Such delay time is inserted between every character being transmitted. The
longer the delay time is, the slower the transmission speed will be.
Inter-Character
Delay… (*0~255)
1) Read the barcode above to specify the inter-character delay.
2) Read the “
Decimal Value” barcode on page 165 for the desired inter-character delay
(millisecond).
3) Read the “Validate” barcode on the same page to complete this setting.
To Next Page
Loading...
Need help?
General
