CipherLab 1266 User Manual

16
Enter Setup
1166/1266 Barcode Scanner User Guide
The example below shows how to set string parameters:
Steps
Action User Feedback if Successful
1 Power on the scanner...
T
he scanner will respond with a long beep
(high tone)
and its LED indicator will
become solid red and go off quickly.
2 Enter the Configuration Mode…
Enter Setup
The scanner will respond with six beeps
(high-low tone repeats three times), and
its LED indicator will become solid blue.
Read a Setup barcode...
For example,
Prefix Code
T
he scanner will respond with one short
beep if reading a special setup barcode
such as “Prefix Code”, indicating the setup
requires reading more barcodes.
<Normal>
Add Left Alt
When “BT HID”, “USB HID” or “Keyboard
Wedge” is configured for interface, Key
T
ype and Key Status will then become
applicable. You may decide whether or not
to change key status when “Normal Key”
is selected for Key Type.
 Refer to Appendix III
3
2
B
Validate
Read the “Hexadecimal Value” barcodes
for the desired character string. For
example, read “2” and “B” for the scanner
to prefix the character “+”.
 Refer to Appendix IV “Hexadecimal
System”
The scanner will respond with two beeps
(high-low tone) when the input values are
validated.
4 Exit the Configuration Mode…
Update OR Abort
Same as for Enter the Configuration Mode.
5 The scanner will automatically restart itself… Same as for Power on the scanner.
Hexadecimal
barcodes
Special setup
barcodes

CipherLab 1266 Specifications

General

Brand	CipherLab
Model	1266
Category	Barcode Reader
Language	English