Information is only shown on a screen if it is active, i.e. if certain tariffs or
powers have not been activated, information on these tariffs, maximum
demands or excess power recordings will not appear on the screen.
The codes for Absolute values are shown below:
Table 6 Absolute energy value codes for contract 1.
AbS (Absolute)
OBIS Without OBIS
KWH 1.18.1 ABSIMP T1 C1-ACT
KWH 1.18.2 ABSIMP T2 C1-ACT
KWH 1.18.3 ABSIMP T3 C1-ACT
KWH 1.18.4 ABSIMP T4 C1-ACT
KWH 1.18.5 ABSIMP T5 C1-ACT
KWH 1.18.6 ABSIMP T6 C1-ACT
KWH 1.18.0 ABSIMP TOTAL
C1-ACT
Tariff periods for Active Energy
from the start of measurement
(if active), included in the total
(period 0)
1.18.x where x = tariff (period)
KVARh 1.58.1 ABSQ1 T1 C1-ACT
KVARh 1.58.2 ABSQ1 T2 C1-ACT
KVARh 1.58.3 ABSQ1 T3 C1-ACT
KVARh 1.58.4 ABSQ1 T4 C1-ACT
KVARh 1.58.5 ABSQ1 T5 C1-ACT
KVARh 1.58.6 ABSQ1 T6 C1-ACT
KVARh 1.58.0 ABSQ1 TOTAL
C1-CO1
Tariff periods for Q1 Reactive
Energy from the start of
measurement (if active),
included in the total (period 0)
1.58.x where x = tariff (period)
Power Excesses 1.12.1 EXCES T1 C1-ACT
Power Excesses 1.12.2 EXCES T2 C1-ACT
Power Excesses 1.12.3 EXCES T3 C1-ACT
Power Excesses 1.12.4 EXCES T4 C1-ACT
Power Excesses 1.12.5 EXCES T5 C1-ACT
Power Excesses 1.12.6 EXCES T6 C1-ACT
Excesses since the last bill
closure (if active)
1.12.x where x = tariff (period)
Maximums 1.16.1 MAXDEM T1 C1-ACT
Maximums 1.16.2 MAXDEM T2 C1-ACT
Maximums 1.16.3 MAXDEM T3 C1-ACT
Maximums 1.16.4 MAXDEM T4 C1-ACT
Maximums 1.16.5 MAXDEM T4 C1-ACT
Maximums 1.16.6 MAXDEM T6 C1-ACT
L11
Maximums 1.16.0 MAXDEM TOTAL
C1-ACT
Maximums from bill closure (if
active), included in the total
1.16.x where x = tariff (period)
To Next Page
Loading...
Need help?
General
