Circutor CIRWATT Series - Standards, Tests, and Protocols; Optical Reader Protocol; Performance and Emissions Standards

Page no. 17
4.4.6.1.- Screen L41 (INFORMATION: CONTRACTED POWERS)
This screen shows information on the contracted powers for contract 1. It only applies
to power excesses in Contract 1. It is a DATA screen.
Table 14 Screen L41. Contracted powers.
Code
Screen Text
OBIS No OBIS
Comments
1.135.1 C1 T1
1.135.2 C1 T2
1.135.3 C1 T3
1.135.4 C1 T4
1.135.5 C1 T5
L41
CONTRAC
TED
POWERS
1.135.6 C1 T6
This is for the values in kW to 2 decimals
of the contracted powers that will be used
to calculate excesses
1.135.x where x = tariff (period), up to 9, in
the event that no power has been
contracted for a tariff the value shown will
be 0
B shows the contract number
4.4.6.2.- Screen L42 (INFORMATION: TRANSFORMATION RATIOS)
This screen shows information on the transformation ratios. As this data does not
correspond to any specific contract but is data general to all, field B will have the value
0. It is a DATA screen.
Table 15 Screen L42. Transformation ratios
Code
Screen Text
OBIS
No OBIS
Comments
0.04.2
I PRI
CURRENT RATIO PRIMARY: This
shows the current ratio primary to 1
decimal
0.04.5
I SEC
CURRENT RATIO SECONDARY:
This shows the current ratio
secondary to 1 decimal
0.04.3
V PRI
VOLTAGE RATIO PRIMARY: This
shows the voltage ratio primary to 1
decimal (compound voltage)
L42
TRANSFOR-
MATION RATIOS
0.04.6
V SEC
VOLTAGE RATIO SECONDARY:
This shows the voltage ratio
secondary to 1 decimal (compound
voltage)