Error! Reference source not found. 1
Introduction
Use this guide to install Cirris Easy-Wire™ software, setup the CH2 tester, connect the CH2
tester to a network, get an overview of the test system, and set up CH2 expandability features.
If you need assistance at any time, call your Cirris Customer Support representative. In the
U.S.A. Cirris Sales and Customer Support may be reached at 1-800-441-9910.
Hipot Warning!
Possible electric shock!
Cirris hipot testers are designed to be safe for operators. Injuries from hipot test
equipment are rare. Still, not every hipot test situation is safe. Hipot testing
does not present a danger to healthy individuals; however, occasional mild
electric shock may be experienced. Small shocks only occur during a hipot test
when the operator touches an energized connection point. Any shock from the
tester may result in a hipot test failure.
Medical Warning!
A child or individual wearing a cardiac pacemaker, an insulin pump, or any
electronically controlled medical device should NOT perform hipot testing.
For ideas on improving hipot safety visit:
www.cirris.com/testing/guidelines/hipot_safety.html
Parts List
Each CH2 order comes with the following parts:
Base Unit
One required per system.
Provides up to 800 points
in 160 point increments.
easy-wire Software USB
flash drive
To Next Page
Loading...
