Setting up a network should be done by your IT personnel and is outside the scope of this
manual. This section describes how to share data between testers on an existing network.
Choose the option below that best fits your requirements:
A. Connecting new CH2 testers to a new network database server
This option requires the Cirris Server Software. If you do not have a copy already,
contact your Cirris sales representative.
B. Connecting new CH2 testers to an existing network database server
This network can include the Easy-Touch, CR, CH2, and CH+ testers all using the same
network database server with Cirris Server Software installed.
C. Changing existing stand-alone testers to a network installation
If you want to save existing test data, you can select one tester as the source for the
network database server. The data on this tester will re-populate the Cirris database
server install and overwrite any existing data on your network server. Test programs that
are unique to the network database server from your remaining testers will need to be
exported to a flash drive and then imported into a new network database.
To Next Page
Loading...
