CISA eSIGNO - Page 38

ESIGNO_SYSTEM_USER_MANUAL_101.DOCX 38/71
S
SS
SYSTEM
YSTEM YSTEM
YSTEM M
MM
MENU
ENUENU
ENU
(
((
(2
22
2)
))
)
TIP
TIPTIP
TIP
The Configuration Options menu lets you
modify the defaults parameters for cards issuing.
E
EE
ENCODER
NCODER NCODER
NCODER M
MM
MODE
ODE ODE
ODE
M
MM
MENU
ENUENU
ENU
C
CC
C
ONFIGURATION
ONFIGURATION ONFIGURATION
ONFIGURATION
O
OO
O
PTIONS
PTIONSPTIONS
PTIONS
To access this menu, press , navigate into the menu with and select System Menu and
then Configuration Options by pressing .
These are the default values for guest cards issue: guest stay duration,
number of copies to be issued and the check-out time.
Delay added to end of validity time sent by the PMS to the encoder.
After being idle for this time period, the system goes into standby
mode: it’s now necessary to login with operator card (0 = no timeout).
After being idle for this time period, the system ends the operation
(e.g. pw input) and returns to the card issuing menu (0 = no timeout).
Enable this warning message to be informed that the room you are
creating a card for is busy.
Setting this value, you can decide whether a newly issued guest card
has the Override Privacy function or not.
This is the number of credits awarded by default to each guest card.
Enable this warning message to be informed that the card you are
creating has already been written and is still valid.
These are the category of utility doors you want to allow access to
by
default to all guest and staff cards, respectively.
After enabling this field, the staff cards will have history on board by
default.
Type here validation hours for staff and guest cards repectively.
Disable history and validation options editing when issuing cards.
Enabling this field, it will be mandatory to type the user’s name in the
moment the card is issued.
Enabling this field, it is possible to use the CS7 card (which is faster to
read and has more memory, compared to a CS5 card) additional
features, like the extended keyplan. This feature works only if the
firmware installed on the locks is up to date with that on the encoder.