CISA eSIGNO - Page 56

ESIGNO_SYSTEM_USER_MANUAL_101.DOCX 56/71
S
SS
SERVICE
ERVICE ERVICE
ERVICE C
CC
CARD
ARD ARD
ARD M
MM
MENU
ENUENU
ENU
(3)
(3)(3)
(3)
HHI
HHIHHI
HHI M
MM
MODE
ODE ODE
ODE
M
MM
MENU
ENUENU
ENU
These are the possible operations:
• AUTO-OFFICE ON: the lock is always open during the specified time shift;
• AUTO-LOCK OUT: it locks out the specified cards (Guest, Staff 1, 2, 3, 4) for the specified time shift;
• AUTO-MOTOR ON: this function actives the motor inside the lock for a cycle of 5 sec. It can be
useful to prevent motor blocking in particular hostile environment of installation. This autoprogram
is regulated by a parameter inside the Change Opening Time menu, called MAX MOT.IDLE [DD]: it
permits to set the day delay between last and current motor activations by the autoprogram;
• AUTO-INACTIVE: current autoprogram is not configured.
R
RR
R EAD
EADEAD
EAD /U
/U/U
/U PDATE
PDATEPDATE
PDATE C
CC
C URRENT
URRENT URRENT
URRENT A
AA
A UTOPROGRAMS
UTOPROGRAMSUTOPROGRAMS
UTOPROGRAMS
The Read Current Autoprograms menu allows you to encode a dedicated service card, to be
presented to a device; in this way, all the details about the autoprograms currently residing inside the
device will be downloaded into the card. Then, by entering the Update Current Autoprograms menu,
the user is asked to present the card to the encoder, which uploads all the autoprograms’ details. It is
now possible to edit all these details. After confirming the changes, the encoder asks for the card to be
re-encoded. By presenting the card to the device again, all the residing autoprograms will be updated.
C
CC
C REATE
REATE REATE
REATE B
BB
B ATTERY
ATTERY ATTERY
ATTERY C
CC
C HANGE
HANGEHANGE
HANGE
This menu allows the creation of a Battery Change service card. With this specific card, it is possible to
change the cylinder batteries. By presenting the card to the cylinder, the two pins blocking the
cylinder head carter become retractable; now, it is possible to take the carter off the cylinder head by
using the proper tool and to replace the batteries. After that, the cylinder head carter can be put in
place again and blocked by presenting the Battery Change card a second time.
C
CC
C REATE
REATE REATE
REATE M
MM
M OUNT
OUNTOUNT
OUNT /D
/D/D
/D ISMOUNT
ISMOUNTISMOUNT
ISMOUNT
This menu allows the creation of a Mount/Dismount service card. With this specific card, it is possible
to take the cylinder head off its body. By presenting the card to the cylinder, the cylinder head
becomes integral with the cam; to take the head off the cylinder body, rotate it while pulling; the
opposite operation can be done by putting the head back in place and presenting the
Mount/Dismount service card a second time.
C
CC
C ONFIGURATION
ONFIGURATION ONFIGURATION
ONFIGURATION O
OO
O PTIONS
PTIONSPTIONS
PTIONS
This menu allows to set the duration (in days) of the service cards issued through the previous menus
(Synchro, Init, Reset, Device Info, Autoprograms, Battery Change, Mount/Dismount). The default
duration is 365 days.