Cisco 11503 - CSS Content Services Switch User Manual

4-55
Cisco Content Services Switch Administration Guide
OL-5647-02
Chapter 4 Using the CSS Logging Features
Frequently Queried Log Messages
NETMAN-5: Generic:LINK UP for
3/1
SYSSOFT-7: NP55_connection.c
512: Connection already open or
reserved
SYSSOFT-3: NP55 Driver:
Connection already open or
reserved
SYSSOFT-2: VccAddVc:open conn
failed w/ stat = -1; iVc 320;
eVc 290
FLOWMGR-7: FM_GetIpv4Vc: Warning
VCC_FP_IPV4_DC failed
The flow manager tried to reallocate a
Virtual Circuit that was already
established.
These messages occur when the port is
coming up. They do not represent a
problem. The messages are most
noticeable at the end of boot time if
you connected through the console.
NETMAN-7:
clm_ProcessStdAction:ERROR->Acti
on<clms_dir>not found
NETMAN-7: CLM:ERROR from
clm_DispatchActionRoutine()
An invalid CLI command was entered.
In this example, a user entered the dir
command in debug mode and specified
an invalid directory. For example:
(debug)# dir d:
NETMAN-7: SNMP:UNKNOWN RSP
(493512
NETMAN-7: SNMP:(493512) Index =
1 <NO_SUCH_NAME>
A valid SNMP agent (community
string matched) is attempting to set an
invalid object and the CSS does not
recognize the object.
NETMAN-7:
TSM:tsm_SendToCLA:ERROR->Write
This security manager message is
associated with line data moving
through the stack after a line has been
disconnected (Telnet application
disconnect). This message is at
DEBUG level for developer
information purposes only.
NETMAN-7:
ASUPPORT:as_SyncTask:ERROR->No
registered reciever for MT:5/1.0
W
This is an informational message. No
further action is required.
Table 4-8 Cisco 11500 Series CSS Log Messages (continued)
Log Message (sys.log: Subsystem
Name, Level, and Message) Cause and Resolution

Cisco 11503 - CSS Content Services Switch Specifications

General

Brand	Cisco
Model	11503 - CSS Content Services Switch
Category	Switch
Language	English